BTW the difference in souping up an aircraft piston engine compared to a car engine
is the aircraft engine is right out at the material limits for heat and
strength. The cylinder heads run at a temperature right out at the limit for
aluminum. If you expect to get more HP out of an aircraft engine you must
also expect to get a shorter life, for, not only the cylinder heads, but every
other part in the aircraft engine. The best materials for the job are used in
aircraft engines and they run at the maximum allowable stress level for the
expected life unlike a car piston engine where the cheapest materials are used
commensurate with the car engines low duty cycle.
This is done in aircraft engines to keep the weight as low as possible. An
air cooled aircraft piston engine is a remarkably heavy duty piston engine
for its weight.
When you soup up a car engine you can buy aircraft quality parts for it
such as 4140 cranks and 4130 rods to enhance the life with higher HP.
The Mazda rotary is an exception and I dread the day Ford forces Mazda to
cheapen it up with... say... a cast iron e-shaft.
Paul Lamar
"Quirk, Kevin KA" wrote:
Does anyone know the actual material specs for Mazda's eccentric shaft?
Kevin.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org