Francois St-Germain wrote:
Hi group,I want to install a Mazda single
rotor on
my
Mini?
It has to work at 6000 rpm cont. 70 hp.
How does it sound to you?
Frank
Very heavy Francois. The HP and durability are
no
problem at all.
We need a light weight 100 HP rotary.
How about it Dr. Moller?
Paul Lamar
Do you know the weight of the single rotor no
reduction drive?
100 lbs is still good enough!
Not exactly. I would guess right around 135 pounds
stripped bare.
A bare 13B weighs 190 pounds. It is hard to cut 90
pound by just eliminating one rotor, one rotor
housing and the intermediate
housing. The front and rear housings are the heavy
ones.
Some part weights from an old message:
front housing (cast iron) 32 lbs
middle housing (cast iron) 35 lbs
rear housing (cast iron) 40 lbs
crank shaft 18 lbs.
rotors 9 to 9.5 pounds.
I think it would be well over 100 pounds unless
you bought an
aluminum back housing from Racing Beat. With the
required steel main bearing
carrier and phasing gear you might save 20 or 25
pounds. In that case you
might get it down to near 100 pounds depending on
the flywheel used.
The 13B starter, for example is 7 pounds and a
very small alternator
is 5 pounds. This does not include the radiator,
water pump, or coolant weight
which weighs roughly 8 pounds per gallon. As far
as I can tell from talking to
people that have built Mazda one rotors, you must
idle the one rotor with
a light weight flywheel at about 1500 RPM to
smooth the torque pulses.
I don't consider it a very promising engine for a
mini 500.
It is hard to beat an aluminum two cycle piston
engine on power
to weight ratio in this HP range.
BTW did the Mini 500 company go bankrupt? What is
the current status?
Paul Lamar
Frank, I have not been able to talk anybody into
trying this so far but
the one rotor would be ideal as you would have only
two housings to make.
Do you have access to a mill? The idea is to cut
away a stock junk
end housing and copy it exactly in aluminum and
steel plate.
An NC mill would make it easier once the program was
written and debugged.
Warning there is a lot of R&D involved in this. I
would make only
the rear housing first and see if it works. The
front housing
is more complicated because of the oil pump among
other things.
Paul Lamar
Thank you Paul you give me a lot of good informations.
The idea of building my own end housing would be great
if I was equiped with a mill or know somebody that has
one but it is not my case.
Do you think the racer team work on that kind of
problem?Where do you take the drawing you've sent?
Please forgive my poor english(I'm french)I'm working
on it!
If we are lucky somebody might try it soon.
Perhaps Rickay@aol.com There seems to be a large
demand for light weight 70 to 100 HP engines under 100 pounds.
Too bad Wankel of Germany went belly up.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org