Subject: Quality Engines and Components from Reputable people in Australia
From: Paul
Date: 2/18/2001, 2:34 PM

Leon Promet wrote:


ENGINE MANAGEMENT SYSTEMS

 I can supply any quality Australian Made Engine Management System.
 MicroTech,  Motec,  Autronics,  Haltech etc.  I'll guarantee to beat
anyone else's price!

In particular,  I  can now supply and support the latest model digital
MicroTech Engine Management Systems which will run 20Bs as well as 13Bs and
most EFI piston engines. The digital ones can be had for fuel only or fully
sequential fuel and ignition,  and will work off either the distributor
drive type crank angle sensor,  or the later pickups on the front cover of
the '93 ~ on engines.  They can be configured for direct fire of one coil
per plug (The ECU has built in coil igniters),  or can run the factory
coils with the dual post Leading coil pack.

I have known the MicroTech designer for many years,  and did a lot of the
early developmental work on turbo and non turbo rotaries with him.

I've just fitted one to a '91 13B turbo of a client,  and another to '91 NA
13B which I have just overhauled and installed into my own good lady's
Series 1 '79 RX-7. Really impressive!

I only replaced the one on the RX7 (early screwdriver adjustable Microtech
D4 "fuel only" computer) because the MAP sensor finally went belly up.
 After 7 years!!  It's been on this car since 1993 and has had a pretty
hard time.  It's in being repaired now,  and will go another 7~10 years.

Here's the good part.  The new MT-8 sells for $1250 AUD  FOB each
(including the hand set).  (At that price,  you can afford true DUAL
redundancy at less than the price of either a single Haltech or a Motec).
 They are supplied already programmed within 10% on the rich side (for
safety) of best tune for whatever engine is specified.

MicroTech computers are super easy to tune via an LCD hand set (NO LAPTOP
necessary)  The ECU is not much larger than the size of a 30s cigarette
packet.  Super reliable,  and have won lots of races here in Oz when fitted
to rotaries in both drag and circuit racers.

Best wishes & kindest regards,

Leon Promet

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org