"Rosine, Steve" wrote:

The time has come to publish my PSRU work.  This is an original design

with

features borrowed from others, and what has been discussed the last couple

Steve,
I'm very impressed, although easily impressed as I have no particular
knowledge in this area.
Please tell me, how do you get the PSRU 'press fit case' apart for
inspection - would it be feasible/practical
to have flanges(ends of joining cases) and bolted together?
How is the PSRU going (any problems so far) - what time do you have up
 have you given it a good testing) ?

Is it possible to purchase plans off you ? as we "down under" have a
difficult time with the exchange rate and even if it cost me twice as much
as what you paid ( but it wouldn't) - it's still cheap comparatively
speaking !

George (down under)

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org