Subject: Self Sealing Washers / Tension Bolts
From: Paul
Date: 2/20/2001, 12:11 PM

Ken Powell wrote:

Hi Ed,
I came up with the following measurements:
   End Housing bolt hole dia - 0.403"
   End housing hole bevel is ~45 degrees and ~0.064" deep
      (I'm just guessing here - The only way I can think to measure
       this would be to make a clay impression and then measure it)
   Tension bolt dia - 0.402" (untapered next to hex head of bolt)
   Washer outside dia - 0.707"

Wow!  Note that there is only .001" differnece in the hole in the
housing and the bolt diameter.  Wished I had measured to the nearest
1/2 thousanths.

Ken Powell

  Hi Ed,
  I am at the office so I do not have an end housing to look at - the
  original washers have a cone shaped sealing rubber, is this required
  because of a recess in the end housing?  I'll take a look and let you know
  what I find in the morning.

  Ken Powell

   Hi Ken,

      I am just looking at various options for those Tension bolt washers.  Unfo
rtunately I threw all my old ones from the rebuild away.  I have also found some
 cone shaped rubber washers which could possibly be combined with a washer (perh
aps the belleville type - cone shaped washer).  Given what's been identified as
replacements for the major "O" rings, that only leaves a few specialized items s
uch as the tension bolt washers to nail down.

     I know that Bruce Turrentine has combined a washer and "O" ring for the ten
sion bolts, but I am hoping to find something that combined the two.
  Will keep looking and let you know what I find.

  Ed  Anderson


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org