Subject: PM parts limitations
From: Paul
Date: 2/24/2001, 9:35 PM


Yes it certainly looks like a cast iron brittle fracture.
I don't think Everett tried it with torque isolation however.

Oh well I think we may be able to weld a large .25 inch thick
4130 washer on the back side of the bulkhead that contacts the
prop shaft. That should distribute the stress better. If that does not
pass the hammer test I think it would be not be all that hard to machine
one out of 4130. What weight hammer did you use?

Paul Lamar

I used Laura's 14 Oz claw hammer.  Sorry, don't have data on hammer velocity
at impact :-)
 I'm not qualified to say whether the PM bulkhead can be welded to or not.
Anybody know?
The bulkhead would be a job to machine due to the teeth that engage the
ringgear.  The 75 or so teeth have to cut on the same helical bias as the
gear just to keep it interesting.  I suspect this is why Ford did it in PM
to begin with.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

High temp epoxy and a .25 inch thick 4130 four inch dia. washer 
bonded to the back of the Ford bulkhead would almost work. 
I get something like 7 square inches of bond area. 

At 3000 psi that is 21,000 pounds shear.
The outer 1/2 inch on a 3 inch diameter is about 4.5 square
inches or 13,500 pounds of shear. 800 foot pounds at 
or 9600 inch pounds at a 1.5 inch radius is 6400 pounds.
Half the capability of the epoxy bond. Looks like the epoxy 
should then handle 1600 ft pounds of torque. Not counting the
contribution of the original PM part.

Making one out of 4130 is  a piece of cake in a 3D NC mill. In a normal 
mill you use a rotary fixture set at the helix angle to the fore and aft 
axis.  A stock PM part can be used to index the rotary fixture. Once 
the fixture is made they can be knocked out rather quickly. Index cut... 
index cut... index cut..etc.

Looks like a 1/8 inch end mill would work as a cutter.
A Ford output shaft could be used as part of the rotary fixture.
I am sure you have plenty of those lying around :-)
Do you need a sketch or do you follow me?

If this is the key to making a cheap PSRU with a large diameter hollow
shaft I will make the fixture.

The yellow screws fastening the bulkhead to the hollow shaft 
in this rendering are what we are talking about.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Power-Sport-gear-box-render2.jpg