Subject: Cracked "Bulkhead" was RE: Powersport Ring Gear
From: Paul
Date: 2/25/2001, 10:48 PM

Leon Promet wrote:

Hi Guys,

Can you fill me in with what you are talking about please??.  I'm AWFULLY
confused.  (no smart comments now,  I am very sensitive!!)

What is the "bulkhead" we are talking about.  In a planetary drive??  I
know we torque funny over her in OZ, but a "bulkhead" is usually a
partition in the hull of a ship or the fuselage of an aircraft.  Never head
of a bulkhead in gearboxes before,  so I'm totally flummoxed  as to where
this cracked part fits in to the scheme of things.

Anyway,  looks like it was made out of sintered iron,  which is the normal
El Cheapo way that Ford do things.  If you braze it,  it will just fail
again at the edge of the braze.
The braze,  especially a Nickel Bronze alloy, would be immensely strong,
 so if you give it a crack with a hammer ... *PING*,  it will break
somewhere else.  Give it the old USN flotation test.  If it floats,  keep
it and repair it!!

This is the same stuff Mazda have used in the synchro hubs of a lot of
their gearboxes. (The early pre 1973 Mazda boxes had STEEL hubs,  and they
NEVER broke).  I used to a have a display case full of broken Mazda gearbox
bits,  especially sintered iron synchro hubs!!   No way am I going to have
my butt hanging off a piece of Henry's junk!!  I just hope the Japs
continue to keep them RIGHT away from the rotary stuff.  Blue Oval
engineering seems to have an unhappy knack of being able to turn a silk
purse into a sows ear!

Rule is:

If it 'ain't broke,  don't fix it.
If you KNOW it will break,  then don't use it.

Do it ONCE
Do it RIGHT

Otherwise you get to do it over and over again. ( ... and again ...  and
again ....)

I'll stick to the Powerglide stuff,  and aftermarket stuff at that.  There
is quite a lot of nifty bits available.  Several firms also make racing
stuff for TorqueFlite boxes as well as for Frauds.

http://www.powerglide.com/

http://www.tsr-racing.com/catalog.html

Lots of bulletproof 500 + BHP stuff available for "Glides,  and it ain't
 all that dear either. You can get a 2.11 ratio.    I haven't checked,  but
I think these guys do C6 gear sets as well.

If you really want to look at some really seriously tough stuff,  have a
look at:

http://www.lencoracing.com/

I'm sure you can buy just the gearsets as spares.  Dear as poison,  but we
know they won't break!!  How about a turbo 20B running through a  three
speed air shifted Lenco behind a variable pitch prop??  Maaaaaaaaaaaaate!

Cheers,

Leon Promet

Its the part on the upper right. Tracy was referring to the technique
of drilling a bunch of holes in it and screwing it to a large diameter
hollow prop shaft.

No it won't Leon. The braze material covers the whole back side unlike a weld.
IMHO it is fine the way it is for 800 ft pounds of torque with a stress
level of only 10,000 psi between the holes after drilling  but what the 
heck do I know? It won't pass the 14 oz hammer test :-)

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ford-planet-gears.jpg