Paul,
After seeing the info and rendition of the Powersport drive, referring to
the cracked bulkhead, I was wondering if anyone is aware if they are using
the same C6 ring gear that is used for the planetary drives or is this a
part machined specifically for them?
Dave Kuc
I thought of that after I uploaded it. No they are not using the Ford C6
ring gear and bulkhead. Power Sport is machining that ring gear and bulkhead
out of high strength steel.
After I uploaded that message I was on the way up to the hangar and I thought
of the perfect way of reinforcing the bulkhead. Brazing! Brazing is better
than welding because like epoxy bonding it bonds the two steels together over
the entire large contact area. Unlike epoxy the bond strength is at least 10,000 psi.
No need to machine a new one out of high strength steel. This opens to the
door to a low cost PSRU using off the shelf low cost prop shafts.
I have no doubt it will pass the 14 oz hammer test.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org