Subject: Rosine PSRU & auto power at Sun 'n Fun
From: Paul
Date: 2/26/2001, 3:59 PM

A little back ground on this fractured bulkhead. This is from 
Metallurgy Fundamentals by Daniel A. Brandt.

The bulkhead is powdered metal which failed very much like cast
iron when Tracy hit it with Lor's 14 oz. claw hammer.
Therefor it is in the category of a brittle material.
That does not mean it is necessarily weak however. It might
take a very high stress if evenly distributed. In the case of
the bulkhead it must be pretty good as there are a bunch of little
teeth transferring the torque from the ring gear to the bulkhead
itself.

Ductile material on the other hand deals with stress concentrations,
such as bolt holes, better because there is a bit of tiny local yielding going
on that re-distributes the stress. Ductile materials can fracture
like brittle materials if the shock load is suddenly applied such as 
hitting it with a hammer.

If I had two materials, both with the same size and strength and I were 
going to bolt something to them I would choose the ductile material. The 
big question is; what are the stress capabilities of the powdered metal 
bulkhead? Obviously quite high or it would not stand up to the abuse 
of a truck auto transmission. According to http://www.mpif.org/
this type of material has the same strength as wrought iron or
about 40,000 psi. Not that far away from 4130 at about 60,000 psi.

It is also quite possible to harden 4130 to the point where it becomes brittle.
Back in my car racing days we heat treated 4130 to Rockwell C 50-60 to keep it
in the ductile range. It worked because we crashed the car several times
without the A arms breaking off completely.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

brittle-materials.jpg