Sorry about that inner O ring. I think it will be OK if you put the necked
down part
on the cool intake side of the housing and use a bit of red RTV.
There must be some kind of adhesive that will hold these in place while one
assembles the engine.

marc wiese wrote:

You should be using Hylomar for that!! (Put it on thinly with a flux brush.
It's sticky). This was in Bruce's video!
Marc Wiese-- 

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org