<< Ken Powell wrote:
Ed,
I received the oil control orings yesterday and tried them last
night. I found that the outer oil control oring (ASA568A-158
McMaster-Car part #9319k221) fits pretty well (it's a little too
long but still fits in the scraper ring) but the inner would not
slide into the rotor when mounted in the oil control scraper ring
- the problem is that the section thickness is a little too
large. Did you order one of these also - if so, please see if
you can get it to fit. So we still need an inner oil control
oring and an outer coolant oring. The orings listed below are
correct:
1. Inner coolant oring
part # = 9319K239
asa568a-175
qty = 4, price = $9.94 each
2. Outer oil control oring
part # = 9319K221
asa568a-158
qty = 4, price = $7.17 each
This is the oring that I could not get to fit. I will play
with it some more Wednesday night.
Inner oil control oring
part # = 9319K261
asa568a-245
Ken Powell
Can you buy a spool of O ring material and cut off what you need for the water ring? The Navy went to a system like that, and uses super glue to make water O rings now. Lynn E Hanover.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org