Subject: Simple muffler revisited fish mouth & stabbed holes]
From: Paul
Date: 2/27/2001, 7:19 PM



        How about drilling the holes, then placing a punch or
something inside them and bending it towards the outlet side?
Holes would be in the side but flared outward in the outside
and inward on the inside? Clear???? Virg

Best way to do it is use a soft surface like rubber and a large hammer
with a sharp punch and punch the holes in the SS sheet.
Or use a hydraulic press. Then roll it up into a tube.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org