Subject: Simple muffler revisited fish mouth & stabbed holes
From: Paul
Date: 2/27/2001, 12:34 PM


snip

According to this book I am reading (Scientific Design of Exhaust & Intake
Systems)
a simple fish mouth pipe end is very effective in reducing noise.
You might want to scale this sketch up for 200 HP.

So too are "stabbed" holes (rather than drilled) in sheet metal.
The main principle is skin friction between the exhaust gases and anything
else. Many small tubes with the same area is better than one large tube.

Paul Lamar

  Paul,
    Question? Should extruded side of holes be to inside
 of tube or outside?

  Kelly Troyer


Dyke Delta/13B Rotary Power

Outside. Less drag I would guess.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org