Finn Lassen wrote:
This is what Tracy had to say about my new simple muffler after ground
and fly-by runs without and with the muffler:
"Compared to the straight pipe without the muffler, it was AMAZINGLY
quiet.
If it does not reduce power much, I'd call it totally acceptable."
It's a 24" long 2" OD pipe squeezed mostly closed at the end. 5 rows x
45 holes (225) 1/8" holes with 1/2" spacing on the underside of the
pipe.
Main disadvantage is cockpit floor gets hot enough to melt the heels of
my sneakers. I intend to sandwich 1/8" fiberflax between SS shim and the
bottom of the floor.
BTW, anybody know the boiling point of auto gas at ~ 3 psi?
Finn
According to this book I am reading (Scientific Design of Exhaust & Intake
Systems)
a simple fish mouth pipe end is very effective in reducing noise.
You might want to scale this sketch up for 200 HP.
So too are "stabbed" holes (rather than drilled) in sheet metal.
The main principle is skin friction between the exhaust gases and anything
else. Many small tubes with the same area is better than one large tube.
Paul Lamar
I was planing of drilling the holes in the main pipe inside the muffler and
than punching one side in. This way creating the cheese grate effect. By
choosing proper side to punch-in you can assist the exit of the gasses.
Just an idea?
Bulent
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org