Subject: Teflon encapsulated silicon "O" Ring "adhesive
From: Paul
Date: 2/27/2001, 6:32 AM


Sorry about that inner O ring. I think it will be OK if you put the
necked
down part
on the cool intake side of the housing and use a bit of red RTV.
There must be some kind of adhesive that will hold these in place while
one
assembles the engine.

marc wiese wrote:

You should be using Hylomar for that!! (Put it on thinly with a flux
brush.
It's sticky). This was in Bruce's video!
Marc Wiese--

George Lendich wrote:

Mark,
I think he may be suggesting that the RTV will take up the necked-down area
ie. filling the gap so to speak !!
George (down under)


Yes. I thought if he kept reading he would figure that out.
It is a good idea to read all your messages before responding to any :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org