Subject: Apex seal weight and sizes.
From: Paul
Date: 2/28/2001, 8:41 PM


Mark Steitle wrote:
What is the proper seal/slot clearance?


0.002 to 0.0039 inches. Maximum allowable is 0.0059 inches.
1994 Workshop Manual.

Paul Lamar

Mark Steitle wrote:

Paul,
One last (dumb) question... What's the actual size of a new 3mm apex seal.  Are they actually 3mm +/- .000?, or are they .002 - .0039" smaller in order to fit a 3mm groove?  In other words, if I were to have my rotors ground to accept the 3mm seals, what size should be the finished size of the groove? --- Mark


Not dumb. Good question. I don't have one here to measure.  You could use a stack of feeler
gauges in a rotor slot. I got an old 2 mm  one here with a plastic vernier and it
is measuring about .075.... 2 mm is .0787 my plastic vernier is not good enough
so the jury is still out. Good question. I need a real mic from
up at the hangar.

Anybody with a new apex seal lying around that they can mic? I will try to
remember to do this when I get up to the hangar later today or tomorrow.

Paul Lamar

OK I measured a 2 mm used rotor slot at the hangar and got 
these inches numbers:

0.079
0.080
0.081
0.079
0.080

So it looks like the slot is close to 2 mm at 0.0787 inches

The 3 piece 2 mm apex seals used came out with a micrometer at:

0.0754
0.0753
0.0754
0.0752

So the apex seal itself is not quite 2 mm. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org