> Hi Guys;
> Yep,------Splicing SOLID non Teflon o-rings works
> great, especially if you scarf the ends 45 deg. The
> joint in most cases is stronger than the
> rest...........But, don't even think about doing this
> with a Teflon coated o-rings.......what WILL happen is
> the Teflon covering will eventually break the bond and
> provide an opening for fluid to get thru.
> We learned this the hard way in the chemical and
> pharmaceutical equipment industry. (1.3 million dollar
> lesson)
> Of course, if there is some new hi-tech super duper
> bonding agent that bonds to Teflon as well as the inner
> material (I doubt it) out there, by all means give it a
> shot.........Just remember that if it harms the inner
> material it would be just as bad, as it would cause the
> Teflon coating to collapse.
> The best thing is to keep on searching for the correct
> size, if you want to try a slightly larger one freeze it
> before installation. If it doesn't shrink enough, try
> heating it in the oven and compress it in place.
> This is how we did it on our equipment.
>
> I've been following this closely and I would say you are
> 95% THERE so don't give up.
> Butch
If you are trying to find a substitute for the inner compression sealing O
ring, and it is similar to the 12A seal, just get one too long and splice it
at a 45 degree angle. You don't need to glue the ends together at all. Glue
the ring in the groove with Halomar, and a drop of silicone at the joint.
Center up the joint beside the intake port.
For bridge ported engines, the ring is cut off on each side of the port.
Daryl Drummond puts a small roll pin in the groove on each side of the port.
This keeps the ring from extruding into the intake port and reducing the
pressure on the ring.
I use a chisel smaller than the groove, and punch the bottom of the groove to
stand up a burr in the groove to block it. Takes 10 seconds. I reuse the
water O rings many times with no problem so far. After the first time, they
are too long. I just trim them down and put the joint at the top, so if there
were to be a leak, it would be on top of the engine. No leaks yet.
Lynn E. Hanover >>
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org