How about drilling the holes, then placing a punch or
something inside them and bending it towards the outlet side?
Holes would be in the side but flared outward in the outside
and inward on the inside? Clear???? Virg
Best way to do it is use a soft surface like rubber and a large hammer
with a sharp punch and punch the holes in the SS sheet.
Or use a hydraulic press. Then roll it up into a tube.
Paul Lamar
Paul,
There are easier ways of doing this :-
Firstly - there is a small tool, it looks like a small tapered shaft.
(I have used it, but forget what it was called or what it is made of)
It is used primarily ( in a drill press) to melt holes - through friction
which can use as a nut (when threaded). The tool heats and
pushes an extension into the tube which reformes into a short
3/8 " insert, when cooled.
This can be used on a tube if you want the insert going inward,
It can be used on sheet metal and formed into a tube if you wanted
the insert pointing outward. One could twist the holes if so desired.
It is even easier that drilling or punching etc.
Hope it helps !
George (down under)
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org