Subject: Simple muffler revisited fish mouth & stabbed holes
From: Paul
Date: 2/28/2001, 4:03 PM


        How about drilling the holes, then placing a punch or
something inside them and bending it towards the outlet side?
Holes would be in the side but flared outward in the outside
and inward on the inside? Clear???? Virg

Best way to do it is use a soft surface like rubber and a large hammer
with a sharp punch and punch the holes in the SS sheet.
Or use a hydraulic press. Then roll it up into a tube.

Paul Lamar


"Bass, Jerry" wrote:

Two things, I have egg on my face about the fishmouth. I looked at Finn's
drawing again and saw Fish Tail.  Being a Bass, myself, I should know
better.

On making the holes protrude.  I use a pipe slightly larger than the hole in
the vice, then place the plate with a small hole over the pipe.  Drive a
drift punch down through the hole.  I added 1/4 inch pipe fittings to my 13B
pan this way.  Flair the hole to accept a pipe tap.  jb


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org