Subject: Apex seal weight and sizes. Take N
From: Paul
Date: 3/1/2001, 2:52 PM

Harley wrote:

Apex seal WIDTH:                2.0 mm                  0.079 in
Apex Seal GROOVE:               1.995 ~ 2.012 mm        0.0785 ~ 0.0792
in

How does this work?  Am I reading it wrong or is the seal wider than the
groove?

BTW...Page 73 of my Haynes manual has the apex seal and groove info...at
least for the 86 to 91 13bs...

Harley

Yes I read conflicting information as well. I think measuring things is
still a
good idea. IMHO the slots are 2 mm and 3 mm and the seals are .003 smaller.

Paul Lamar


Leon Promet wrote:

Hi Guys,

Suggest you take it up with Mazda.  All I am doing is reporting what is in
the Factory book!! (one of the reasons why I gave you the readings out of
the different books,  and stressed that it was verbatim!!).

The figure given for the 2 mm REW and the 3 mm RX4 & RX5 seals are
obviously NOMINAL sizes,  and it is the clearance that is important!!
 That's why it is so important to give the engineer your seals (including
corner seals!!) if you are going to get the grooves hogged out.  Clearances
are what matter,  not the actual sizes.

You will notice from  my previous post that on the 3mm  2 piece seals,  the
maximum STANDARD clearance is a little bit less (half a thou).  The wedge
nature of the 3 piece seal tends to take up the little bit extra.  In all
cases,  the maximum clearance is the same (6 thou).  Interestingly,  they
will still continue to run with much larger clearances,  but gas sealing
tends to suffer with an attendant deterioration in fuel consumption and
power output.

The original RX7 Series 4 manual gives the figures as:

Series IV $  Series V 2 mm Specs:

Apex seal WIDTH:                1.910 ~ 1.939  mm       0.0752 ~ 0.0763 in
Apex Seal GROOVE:               1.995 ~ 2.012 mm        0.0785 ~ 0.0792 in
Clearance Standard:             0.062 ~ 0.102 mm        0.0024 ~ 0.0040 in
Limit:                          0.15 mm         0.0059 in

Maximum material condition of the apex seal is:
1.939 mm or 0.0763 in

Minimum material condition of the groove is:
1.995 mm or 0.0785 in

SO according to my math,  the MINIMUM clearance allowed within factory
machining tolerances is:

0.0022 which is a bit over two thou.

Leon Promet

Ever hear of Henry Ford and interchangeably parts Leon? :-)

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org