Subject: Apex seal weight and sizes.
From: Paul
Date: 3/1/2001, 12:40 AM

Leon Promet wrote:

Howdy,

C'mon guys,  I just can't stand it any more.  Has anybody bothered to look
in a workshop manual lately??  How do you expect to be able to build these
suckers properly,  let alone prognosticate on modifications etc without a
workshop manual??  Anyway,  to avoid being accused of being argumentative,
 here's the goss. (Oz for gossip!)

All numbers are quoted verbatim as per Mazda Factory Workshop Manuals.  All
decimal places are AS written in the manuals.  You will notice that the REW
seal width is only given as 2 mm,  with no maximum or minimum material
condition.  The RX4 ~ 5 Manual doesn't give an apex rotor groove width.

Series IV $  Series V 2 mm Specs:

Apex seal WIDTH:                1.910 ~ 1.939  mm       0.0752 ~ 0.0763 in
Apex Seal GROOVE:               1.995 ~ 2.012 mm        0.0785 ~ 0.0792 in
Clearance Standard:             0.062 ~ 0.102 mm        0.0024 ~ 0.0040 in
Limit:                          0.15 mm         0.0059 in

Series VI (REW) 2 mm specs:

Apex seal WIDTH:                2.0 mm                  0.079 in
Apex Seal GROOVE:               1.995 ~ 2.012 mm        0.0785 ~ 0.0792 in
Clearance Standard:             0.051 ~ 0.101 mm        0.002 ~ 0.004 in
Limit:                          0.15 mm         0.0059 in

RX4 & RX5 3 mm Specs:

Apex seal WIDTH:                3 mm                    0.118 in
Apex Seal GROOVE:               N/A                     N/A
Clearance Standard:             0.05 ~ 0.09 mm          0.0020 ~ 0.0035 in
Limit:                          0.15 mm         0.006 in

Just another couple of pieces of gratuitous advice.

If you are going to get the grooves milled or ground,  don't do it until
you have the seals to give to the engineer.  Otherwise,  it will become a
game of "pass the (blame) parcel"

Also,  give the man some of the 3mm corner seals and tell him that as part
of the job,  the apex seal MUST align with the slots in the corner seals
exactly.  There is little or no margin for error here.  I prefer to use the
non keyhole type corner seals (1011~11~321c part # from memory) as a gauge
tool.

Enjoy!

Leon Promet

Ease up Leon. I have the $100 (U.S.) factory 1994 3rd gen Workshop Manual and these specifications
are no where to be found. I checked my factory 1976  13B Cosmo Workshop Manual and the info
is not in there either. What is there is the width of the seal at 3 mm .118 which 
obviously is wrong info. Things must be different in Oz. What page was it on?
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org