Subject: Apex seal weight and sizes.
From: Paul
Date: 3/1/2001, 10:21 AM



Mark Steitle wrote:

Paul,
One last (dumb) question... What's the actual size of a new 3mm apex >seal.  Are they actually 3mm +/- .000?, or are they .002 - .0039" smaller in >order to fit a 3mm groove?  In other words, if I were to have my rotors ground to >accept the 3mm seals, what size should be the finished size of the groove? --- Mark
Not dumb. Good question. I don't have one here to measure.  You could >use a stack of feeler
gauges in a rotor slot. I got an old 2 mm  one here with a plastic >vernier and it
is measuring about .075.... 2 mm is .0787 my plastic vernier is not >good enough
so the jury is still out. Good question. I need a real mic from
up at the hangar.

Anybody with a new apex seal lying around that they can mic? I will try to
remember to do this when I get up to the hangar later today or tomorrow.

Paul Lamar
OK I measured a 2 mm used rotor slot at the hangar and got
these inches numbers:
0.079
0.080
0.081
0.079
0.080
So it looks like the slot is close to 2 mm at 0.0787 inches
The 3 piece 2 mm apex seals used came out with a micrometer at:
0.0754
0.0753
0.0754
0.0752
So the apex seal itself is not quite 2 mm.
Paul Lamar


Just dug up a Hurley 3 mm apex seal that Able Ibarra had in his 700 HP 13B
drag race engine. It measured, with the micrometer, 0.1151 and 0.1152 while 
3 mm is 0.1181. That gives the requisite 0.003 clearance.

Paul Lamar


Mark Steitle wrote:


Paul, thanks for the measurments.  It tells me what I suspected... its the slots, not the apex seals, that are 2mm/3mm. --- Mark-- 


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org