Yvon Cournoyer wrote:
Good morning, Where can we find more information on the construction of the
second type (less bulky-less weight?) that you and Finn are working on?
Thank you. Yvon.
Finn Lassen wrote:
I'm not sure how to describe the "construction" of the "muffler" that I've made,
better than I already did.
I went to the local AutoDiscount auto store and bought a 2' length of 2" OD (1/8"
thick?) exhaust tube (didn't want to experiment on more expensive stainless steel
tubing). I squeezed one end shut (or nearly so, remaining slits are less than
1/8", at a couple of points the material actually touches - more as a result of
trying to squeezing it shut than by design). I then laid out a simple 1/8" hole
pattern on the lower part of the tube. 1/2" spacing between holes. 5 rows of 45
holes = 225 holes. I really should have 256 holes to get the same area as a 2"
tube: 3.14 sq inch = 256 * 3.14 * (1/8 / 2)^2.
Once this one wears out I'll make one in thin (.035) stainless steel.
I guess an unscientific explanation on how it works is that it expands the
incoming 3.14 sq inches area of the tube to 250 sq inches (45.5 * 5.5) , directed
down (away from the cockpit) and into the airstream. I suppose that if I were to
hang the tube across the fuselage rather than along it, I'd get better muffling
result (but more air drag).
Finn
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org