I went to the local AutoDiscount auto store and bought a 2' length of
2" OD (1/8"
thick?) exhaust tube (didn't want to experiment on more expensive
stainless steel
tubing). I squeezed one end shut (or nearly so, remaining slits are
less than
1/8", at a couple of points the material actually touches - more as a
result of
trying to squeezing it shut than by design). I then laid out a simple
1/8" hole
pattern on the lower part of the tube. 1/2" spacing between holes. 5
rows of 45
holes = 225 holes. I really should have 256 holes to get the same area
as a 2"
tube: 3.14 sq inch = 256 * 3.14 * (1/8 / 2)^2.
Once this one wears out I'll make one in thin (.035) stainless steel.
Finn
Finn,
Just one of those on the airplane or one per exhaust port? If you are
passing all of the exhaust flow through just one of these mufflers I would
think that would be quite restrictive and could be costing you some power.
Mike Wills
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org