Subject: Simple muffler revisited fish mouth & stabbed holes
From: Paul
Date: 3/1/2001, 10:13 AM



        How about drilling the holes, then placing a punch or
something inside them and bending it towards the outlet side?
Holes would be in the side but flared outward in the outside
and inward on the inside? Clear???? Virg

Best way to do it is use a soft surface like rubber and a large hammer
with a sharp punch and punch the holes in the SS sheet.
Or use a hydraulic press. Then roll it up into a tube.


Paul Lamar


Lonnie Wood wrote:

Paul,
How could you roll this into a tube without flattening the deformations?
I had some .040 stainless rolled at sheet metal shop for my muffler
and tailpipe. It took multiple passes through the roller, each time with
more pressure. Possibly could be done if the material is fully annealed.
Lonnie Wood


I really did not mean roll it up literally.

Good question however. I would try manual forming it around a pipe with hose
clamps between the perforations (plan ahead for the hose clamps and leave
enough room
for them), remove the pipe  and weld it up. Flanges bent up 90 degrees on
each side
notched for the hose clamps should hold the edges in alignment while
tightening the
hose clamps. Small holes can be drilled in these flanges and screws and nuts
use to
pull things together  towards the end when it is nearly in a circle. After
it is
welded these can be ground or cut off or just left in the muffler.

This is just a guess but it should work.

Paul Lamar

"Bass, Jerry" wrote:

I too have mused over the puckered holes. I think the tail piece should be
made in two halves.  Make a paper pattern of one half and make two on a
press brake.  Drill and pucker holes on one half.  Weld the two halves
together.  Ok

Jerry Bass 

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org