Mike,
I'd like to hear about your muffler's performance when you get it running, I'm thinking of using two 2" ID exhaust runners joining up 31 inches downstream into about a 2 - 2 1/2 inch ID muffler.
Paul,
I'm thinking of using some of that 4.495 dia .020 inconel tube for part of my muffler, say by using the perforated pipe/fishtail tube surrounded by that inconel tube. What say ye?
Brian Trubee
Redmond,Wa
Inconel is the best. Probably overkill for that application as the exhaust gas has lost a lot
of heat by the time it goes through the holes. I remember standing behind Tom Jordans
supercharged 13B in his big eze and looking into the exhaust pipe with the engine
running at max static RPM. The center pipe was white hot inside the muffler to
the point of transparency. If you enclose anything in a muffler case the guts are
going to run extremely hot as they do not have the benefit of cooling of any kind.
Whatever is in there short of Inconel will probably fail sooner or later.
Its not like a car that averages 30 or 40 HP. In aircraft use a 13B is going
to average 150 HP or more so it will destroy any muffler designed for
car use.
Even the guts of my C182 muffler were spit out on the ramp in Valdez
on one of my trips to Alaska during a run up. One of my paxs was standing
along side the airplane when that happened and he got quite upset. After
I shut it off and climbed out of the cockpit he said; "A part of the engine
just came out the exhaust pipe" and pointed to a mangled perforated chunk of
pipe on the ground. I said; "Don't worry we don't really need that part
of the engine" :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org