Subject: adaptor plate fabricator near you?
From: Paul
Date: 3/3/2001, 12:08 PM

marc wiese wrote:

Paul,
Re the adaptor plate; have you tried to contact these people for making the
one you are designing? I understand they "don't have any excess capacity"
but since they are close to you, perhaps you can run by and give them a try?
Marc

Kennedy Engineered Products
38830 17th St. East
Palmdale, CA 93550
(661) 272-1147

Its possible Marc. When I get ready I will send them a drawing.
I finished fitting  the motor mount tubes  yesterday and the jig with
the tubes is in the welders. The motor mount should be done next week.

Leon might come up with a casting made in low wage Oz.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org