Subject: Adaptor plates...... Good news Take 2
From: Paul
Date: 3/6/2001, 3:03 PM

Leon Promet wrote:

Hi Paul,

Getting some pix digitised today,  and will post them this evening my local
time.

See comments below marked ##

SNIP>>

We will put our heads together when I get down there Leon. I am working
that out with my wife as we speak.

##
Please give me as much notice as you can.  I'm pretty busy and might need
to shift commitments and rearrange my schedules. I'm right in the middle of
having some extensive dental work done.

##
 I also need to make sure Jeff is going to be available.  I'd hate you to
lob here,  and find he's off somewhere interstate. He didn't say he was
going away,  but I have spent many years under the tutelage of dear old
Professor Murphy and his infamous "laws".

BTW is 29 inches center to center on the rubber bushings OK with most of
you guys
building a side by side type airplanes?  This will accommodate a stock
turbo, custom
turbo or tangential muffler in the cowl. You RV4 guys will be on your
own.

##
Not necessary.  They can be easily accommodated.  Get some measurements for
them as well,  as once the basic design is made,  we can have removable
sections on the patterns.  It only means the cost of a second pair of
mounting ears which are not as wide.  The other alternative is to have one
basic bell housing,  and have different pairs of demountable brackets,
 just like most vehicles.  This way also makes it easier for machining
purposes.

 The tandem RV8 uses the wide cowling. We will make the PSRU mounting
surface flat
with no holes so Tracy can bolt up his PSRU and make any changes he wishes
except for the 3.550 distance from the back of the engine to the PSRU
mounting
plane.

How does this sound guys? Tracy? Let me know with comments before we make
the patterns
for the castings.

It will look something like this bell housing with
the rubber mounts rotated 90 degrees and lowered to clear the stock turbo
180 degree exhaust pipe. Also the starter will be moved over to this side.

Right now I have no idea of the costs.

##
I did include costings in the previous email.  For the sake of clarity I've
repeated them below:

##
QUOTE:

Preliminary costings are around $475 ~ $575 AUD ($250 ~ $300 USD ) for
individual units,  depending on the bolt pattern drillings on the PSRU
mounting face and complexity of mounting provisions that need to be
incorporated in the patterns etc.  This price could be brought down
considerably if 5 or more units were ordered at a time,  as a lot of the
cost is in the set-up time.  I'm also currently costing having them X-rayed
for casting flaws.  (Not an issue with auto apps,  and none have ever
broken in service,  but  there are a different set of loads applied in an
aero installation and I don't want to take any chances in the air).

END QUOTE

OK guys how does this cost plus shipping sound for a motor  mount bell housing combo?

Put in your request for a center to center distance on the rubber bushings.

I think we should stick to the auto tx flexplate and Tracy damper as we have
a history with these. I don't want to go through R&D on a new damper and flywheel.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org