Subject: Adaptor plates...... Good news Take 3
From: Paul
Date: 3/6/2001, 3:13 PM

Leon Promet wrote:

Hi Paul,, Tracey,

BIG SNIP >>

Sounds good to me.  This eliminates any concerns over lateral stress for
the
engine mount/redrive adapter.  Keep in mind that nothing fits together
without design work.  The adapter thickness needs to be matched to the
input
shaft length,

##
I will obviously need some precise measurements,  lots of pix,  (tip,  when
you take shots of parts in strong sunlight,  use the flash to fill in the
shadows!)

 the damper (if Leon ends up making these) needs to be matched
to the input shaft spline, etc, etc.

##
Is it a standard auto size?  If not,  maybe Paul can bring a sample of the
spline. The people who make the solid centre  button clutches for me have
an enormous range of splined centres.

##
Additionally,  both Jeff and I have several gear cutter contacts that can
make all sorts of different splines  (my old workshop used to be right next
door to one!!),  as this is all part of the business of adapting different
makes of gearboxes and motors.  .  In small batches,  they don't cost all
that much to have made anyway.

   Leon, will the auto trans flexplate
(that I use) fit in the proposed bellhousing?

##
Tracey,  anything is possible.  When we make the new patterns,  I'll see if
I can make it so that it will take either the auto or the manual starter
motor.  The differences are minimal in diameter.

 It is slightly larger in
diameter that the manual stick trans flywheel.  If Leon makes the
flywheel
this would be a non-issue.

##
Let me get all the exact measurements and I'll see how much work is
involved in doing it.  I'd like to be able to accommodate various PSRU
units,  especially yours.

##
It is a matter of getting the starter flange offset correct (the auto
starter is a lot closer to the rear housing),  boring the starter hole in
the correct place,  and drilling and tapping the second (bottom) retaining
hole.  The top hole is determined by the hole in the rear housing,  and it
is the same for both starters.  Got some pix coming later today once I get
them digitised.

##
The main reason I was looking at doing a flywheel/driveplate was so that I
could incorporate a permanent magnet 12V generator.  Otherwise,  the auto
flex plate is the way to go,  as you can usually get them for free!

##
However,  I don't like the idea of having my sparks dependant on the health
and well being of a thin rubber band,  hence the idea of a permanent magnet
generator.  Stay tuned!!  I'll discuss this further with Paul when he gets
here.  It's still a capricious phantasm in my addled brain right now.

Cheers,  Leon


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org