Subject: John Moran's Prop Hub Shank
From: Paul
Date: 3/6/2001, 9:11 PM


Paul,

In looking at the photo of John Moran's prop hub shank, does this mate with
the threaded bushing that you have a photo of and is this bushing "wrapped"
with the composite fibers of a composite prop blade?  Also, could this setup
be used with blades made similar to the MT and Hoffman props, using a wooden
core?  Thanks.

Dave Kuc

Yes.  Here is a suggestion for building the blades using a wood core.

Hold off on building one of these Dave. I think we have somebody interested 
in manufacturing this design. It will be awhile before we get a prototype 
built and tested so the design may change depending on the results of the 
testing. We intend doing some severe ground testing including applying 
gyroscopic forces due to aircraft pitch changes before we flight test it.

I also do intend to reduce the weight of the prop shank parts.

You are free to build it as is but I would only test it on a ground test
stand and not fly it yet. There may be some severe problems that we don't
know about. If you want to contribute to this effort  I will send you some 
suggested sketches for a test stand that continuously changes pitch using 
an electric motor.

I think we can get the cost down to a reasonably range if you can build your
own carbon fiber blades. Therein lies most of the labor cost.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

woodHUB.GIF