Peter Cowan/Lexi Cameron wrote:
Does any one know for sure whether it is Boiled or raw linseed oil
that
is used
to coat inside of 4130? Thanks
Peter.
AC 43.13-1A Says (in part) "Coat the interior by flushing with hot
linseed
oil
or paralketone, or other corrosion inhibitor. The flushing liquid is
usually
introduced through small holes drilled in the tubing. Allow the flushing
liquid to drian and plug the holes with a screw or by other means to
prevent
the entry of moisture. " So - no real answer here, altho it may not
make a
difference.
You *DO* have AC43.13-1A (new replacement, actually) on order, don't
you?
;-)
Bill
Long EZ builder & pilot
BSME, MSME
Peter Cowan/Lexi Cameron wrote:
Here's an idea for the "oil injection" process. I am using a $5 clamp on
valve available at hardware stores that is used to obtain water from 1/2
inch copper pipe for furnace humidifiers. They require about an 1/8" hole in
the tube and come with a nice rubber seal. Outlet is 1/4" copper. This I
will hook up to an old fire extinguisher canister that accepts air pressure
via a tire valve.
Apparently the function of the oil is to use up the oxygen. No oxygen, no
rust. Hmmm, why not flood with argon/co2?
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org