OK guys how does this cost plus shipping sound for a motor mount bell housing
combo?
Put in your request for a center to center distance on the rubber bushings.
I think we should stick to the auto tx flexplate and Tracy damper as we have
a history with these. I don't want to go through R&D on a new damper and
flywheel.
Paul Lamar
Paul;
Why don't you recommend what the MINIMUM distance
between mts. should be, you're certainly more qualified
and further along than most of us.
After all, we all have to build an engine mt. This way
we at least know what the min. max. widths are and adapt
accordingly.
As always just a suggestion :-)
Butch--
The minimum would be about 14 inches center to center which would put the
rubber right next to the bell housing. There are several drawbacks to this.
One; undesirable heat transfer to the rubber bushings.
Two; difficulty in designing a motor mount that will clear the exhaust.
Three; stiffer mounts required for torsional considerations.
Let me put this last objection in engineering terms in case Jeff objects.
The ratio of torsional stiffness to vertical stiffness is less favorable
with the rubber mounts closer together. To explain this better, the limit would
be if the mounts were at infinity. In that case the torsional loads would
approach zero and the rubber mount would only see vertical loads.
On the other hand if the rubber mounts were near the engine center line
the torsional loads would approach infinity with the same vertical loads.
In short I highly recommend at least 29 inches center to center.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org