"Bass, Jerry" wrote:

I made a 'servo' control with a handle that you move and the flap

follows. I

use a Flap screw from Van's. It draws 1.25 amps, and my Transistors

will

drive 2 amps.  $200 for the kit.

Jerry Bass

Jerry,
Do you have more information on the KIT?
Thanks.
Vlad
N1UT - Velocity Elite, RG, Mazda 20B rotary, NA - engine installation in

progress

http://www.N1UT.velocity-air.com

 "Bass, Jerry" wrote:

Measure your Flap Motor current with someone holding back on the flap or
flap lever to increase the current to max.  I can take pix of mine if you
need.

Jerry Bass

Jerry, in previous letter you statue, you have an kit for $200 whcich
include ...? And this kit could do ....... ?
I do not look on way how need to measure max. current when
flaps is overloaded. What I need is find a source to buy good quality
servos with or without electronics/electromechanics.
Please describe what you kit do and where I could get what is not
included in the kit.
Thanks.
Vlad
N1UT - Velocity Elite, RG, Mazda 20B rotary, NA - engine installation in progress
http://www.N1UT.velocity-air.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org