Bill Freeman wrote:
Paul,
My opinion is devalued considerably by the fact that I
will not be ordering one, but it seems to me that a base
bellhousing with a pair of pads to accept any one of
several different length bolt-on motor mount brackets
(also cast) would make an extremely flexible system.
Perhaps some may need to mix lengths for some particular
reason (long on one and short on the other) and the qty of
the large bellhousing might be larger, helping with the
price. A totally non-std application could use welded
steel tube truss brackets to fit essentially anything. I
believe Leon mentioned this in his e-mail. Three different
"brackets" would be extremely adaptable.
Bill
Long EZ builder & pilot
BSME, MSME
Especially if they were symmetrical and could be used on either
side.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org