Finn Lassen wrote:
Yesterday I decided to change oil and filter; about 60 hours since last
change.
I turned the engine to get oil pressure for about 30 seconds with no
joy. As I was a quart short, I packed it in and went to work. Today I
came back, added the last quart, and turned and turned the engine (even
ran it for a minute or two < 2000 RPM) - still zero oil pressure. Seems
I tried everything - backfilling oil, adding oil to the filter,
loosening fittings "to make it easier for the pump to fill up the lines"
!!??). (Of course, messing with a perfectly good fitting just resulted
in a leak there I now have to fix.) In desperation, after 4 hours, I
finally put the old filter back ("in case I had gotten a bad new
filter"). Fortunately noone had emptied that trash can. Lo and behold!
Instant oil pressure!
When I bought the new filter I decided to get a higher quality FRAM
filter which has a membrane preventing oil from draining back to the
pump (keeping the filter full of oil). It finally dawned on me that when
I moved the filter down near the front outlet (home made adapter plate),
I had reversed in and out to the filter! Apparently the oil is supposed
to come in on the outer circle and out through the center?
So here's the question: can you think of any liabilities with flowing
the oil the wrong way through the oil filter (obviously can't use the
one with the one-way "valve")?
Could this be the reason I've had to turn the engine so long before
getting oil pressure the first and earlier times I changed oil?
Up till now I've been using the cheap Perculator (?) filter from
Discount Auto Parts.
Finn
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org