sinkas wrote:
I am about to install a metering pump adaptor on my daily driver, (well monthly driver I guess)
and was wondering if any of you ahd any suggestions about a level sensor that I could use for the job.
I have been considering the coolant level sensor from an early RX7, or possibly the low oil sensor from any post RX5 mazda...? I also have little idea about how to wire one up
Case
"Alma Matters"
Use an ohm meter to measure the resistance of the oil level sensor
when and when not covered with oil. I suspect you will need some
sort of amplifier to light a light as the stock unit is fed into
what is known as a "coolant level unit." Don't try to connect it directly
to a light and 12 volts as you could burn it out.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org