Bill Freeman wrote:
Paul,
My opinion is devalued considerably by the fact
that I
will not be ordering one, but it seems to me that
a base
bellhousing with a pair of pads to accept any one
of
several different length bolt-on motor mount
brackets
(also cast) would make an extremely flexible
system.
Perhaps some may need to mix lengths for some
particular
reason (long on one and short on the other) and
the qty of
the large bellhousing might be larger, helping
with the
price. A totally non-std application could use
welded
steel tube truss brackets to fit essentially
anything. I
believe Leon mentioned this in his e-mail. Three
different
"brackets" would be extremely adaptable.
Bill
Long EZ builder & pilot
BSME, MSME
Especially if they were symmetrical and could be
used on either
side.
Paul Lamar
DENIS SMITH wrote:
Paul, Would these bell housings fit a 20B and if so
how much lighter would they be than the stock ones?
Yes they should fit a 20B. We will see to it.
I don't think they will be lighter. The stock ones are high pressure die
cast and hard to beat on weight. The problem is the stock ones are too deep
for Tracy's input shaft and too deep anyway as they would make the PSRU too long.
Besides that they don't have the built in motor mounts.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org