<< Ed Anderson wrote:
Finn,
When I first installed my remote oil filter (I use a Wolf Aircraft
fixture) I had the intake and output reversed. In my case using a Champion
aircraft filter oil refused to flow as well. I went through all the
analysis steps from plugged line to bad oil filter until I reversed the
hoses, then it worked fine.
By the way, I believe that the oil comes into the inside of the filter
element and flows through the filter material. At least on my set up, the
hose from the oil pump output fitting on the front cover goes to the center
of the oil filter bracket which though a 3/4" pipe (which the oil filter
screws on) goes down into the center of the oil can.
Hope to see you at Tracy's tomorrow
Best Regards
Ed Anderson
Every screw on filter I have seen flows outside-in. Oil goes into the circle of small holes around the outside hole with the mounting threads. Oil pressure pushes open the anti drainback valve (under the small holes) and flows into the outside area around the filter element. Then through the element into the central core.
Out of the element through the central hole. If the hoses are reversed and the element has an anti drainback valve, you will get no flow. If the element has no anti drainback valve, then you can reverse the hoses and still get good flow.........up until when you blow the element off of the central core, and fill the engine with oil and paper. Always use filters with high performance cans and anti drainback valves. K&N makes a line of such filters with wrenching flats on the can.
Lynn E. Hanover
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org