Subject: Low level sensor for remote injector oil reservoir (metering pump adaptor application)??
From: Paul
Date: 3/10/2001, 8:29 PM


| > > sinkas wrote:
| > > >
| > > > I am about to install a metering pump adaptor on my daily driver, (well
| > monthly driver I guess)
| > > > and was wondering if any of you ahd any suggestions about a level sensor
| > that I could use for the job.
| > > > I have been considering the coolant level sensor from an early RX7, or
| > possibly the low oil sensor from any post RX5 mazda...? I also have little
| > idea about how to wire one up
| > > >
| > > > Case
| > > > "Alma Matters"


| > > Use an ohm meter to measure the resistance of the oil level sensor
| > > when and when not covered with oil.   I suspect you will need some
| > > sort of amplifier to light a light as the stock unit is fed into
| > > what is known as a "coolant level unit." Don't try to connect it directly
| > > to a light and 12 volts as you could burn it out.
| > >
| > > Paul Lamar


| Richard Sohn wrote:
| >
| > You may want to look at some of the level monitoring HDW used on outboard
| > motors. There is usually 2 systems, one in a main tank with an electric oil
| > pump and another one in the header tank at the motor.  I have seen even dual
| > acting sensors for low level and for full. I will put something like that in
| > my RX7 when I get to it.
| > Richard.

| That would be another good product for you Richard.
|
| Paul Lamar

sinkas wrote:

But what voltage does the Outbord use, or is it all self servicing..?

Case

"Alma Matters"

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org