Subject: Low level sensor for remote injector oil reservoir (metering pumpadaptor application)??
From: Paul
Date: 3/10/2001, 8:28 PM


|
| > > > I am about to install a metering pump adaptor on my daily driver, (well
| > > monthly driver I guess)
| > > > and was wondering if any of you ahd any suggestions about a level
| > > sensor that I could use for the job.
| > > > I have been considering the coolant level sensor from an early RX7, or
| > > possibly the low oil sensor from any post RX5 mazda...? I also have
| > > little idea about how to wire one up

| David Doshay wrote:
| >
| > I'd use the sensor Mazda uses in the master brake cylinder.  Place it at the
| > bottom of a step in the tank, so you would know that you have a few ounces
| > left. This sensor is a simple float and magnetic switch.
| >
| > David

sinkas wrote:

Would this sensor be easy to rig up a warning light to?

Case

Yes. Very simple. Merely wire the switch in series with the light bulb.
If there is only one wire coming out of the sensor (switch) the other end of the
sensor is grounded.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org