Subject: Low level sensor for remote injector oil reservoir.
From: Paul
Date: 3/10/2001, 8:42 PM


sinkas wrote:

I am about to install a metering pump adaptor on my daily driver, (well
monthly driver I guess)
and was wondering if any of you ahd any suggestions about a level sensor
that I could use for the job.
I have been considering the coolant level sensor from an early RX7, or
possibly the low oil sensor from any post RX5 mazda...? I also have little
idea about how to wire one up

Case
"Alma Matters"


Use an ohm meter to measure the resistance of the oil level sensor
when and when not covered with oil.   I suspect you will need some
sort of amplifier to light a light as the stock unit is fed into
what is known as a "coolant level unit." Don't try to connect it directly
to a light and 12 volts as you could burn it out.

Paul Lamar


Richard Sohn wrote:

You may want to look at some of the level monitoring HDW used on outboard
motors. There is usually 2 systems, one in a main tank with an electric oil
pump and another one in the header tank at the motor.  I have seen even dual
acting sensors for low level and for full. I will put something like that in
my RX7 when I get to it.
Richard.


Bill Freeman wrote:

 AS&S used to sell a small integrated float switch mounted on the end of a
plastic
bolt.  The ~1" long float moved a magnet into proximity of (I assume) a reed
switch
and kept 'electricicals' out of the fluid being measured, like fuel.   If
they still sell
it, it would be ideal.  I think it screwed into a NPT boss on your tank at
the appropriate
warning level.

Bill

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org