Subject: Oil pressure woes
From: Paul
Date: 3/15/2001, 1:32 PM


Every screw on filter I have seen flows outside-in. Oil goes into the
circle of small holes around the outside hole with the mounting threads. Oil
pressure pushes open the anti drainback valve (under the small holes) and
flows into the outside area around the filter element. Then through the
element into the central core.
Out of the element through the central hole. If the hoses are reversed
and the element has an anti drainback valve, you will get no flow. If the
element has no anti drainback valve, then you can reverse the hoses and
still get good flow.........up until when you blow the element off of the
central core, and fill the engine with oil and paper. Always use filters
with high performance cans and anti drainback valves. K&N makes a line of
such filters with wrenching flats on the can.
Lynn E. Hanover


Lynn,
    You are correct and I had it wrong.  Fortunately, only my memory was
bad, my oil filter fitting is correctly connected.  Thanks for the
correction.

Ed

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org