. Basically, we have discovered it is fairly
easy to assembly the oil pump with woodruff key, drive sprocket, washer and
nut and NOT HAVE THE KEY in the keyway. It is possible to push the key out
of the keyway when sliding on the drive sprocket and to trap the key
between
the drive sprocket and pump housing (mark of the key having been embedded
in the pump aluminum shaft boss were clearly evident). Furthermore, there
is plenty of shaft threads left sticking past the torqued nut to not raise
any notice.
marc wiese wrote:
You bet this is common. I just rebuilt a 91 nt and had a heck of a time
getting that oil pump woodruff key in correctly. It took me 6 or 7 tries
before it seated right. This is a stumbling block in the rebuild process. I
believe I remember testing if the key was in by turning the gear [I put the
gear, chain and sprocket on at the same time] by hand BEFORE I bolted the
gear down-(which does not 'trap' it rigidly underneath) I can also say that
adjusting the end play took time, patience, and a lot of different spacers!
Maybe Bruce has a trick for this up his sleeve?
Marc Wiese
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org