Subject: Oil Pressure - Flying without the Woodruff key
From: Paul
Date: 3/16/2001, 11:49 PM


"Harley, Ageless Wings" wrote:

It is possible to push the key out of the keyway when sliding on the
drive
sprocket and to trap the key between the drive sprocket and pump
housing<<

Might it pay to install a pin in the keyway (maybe a roll pin so that it
has
little chance of coming out later)in a blind hole to keep the key from
sliding back as the sprocket is pushed on?

Harley


A possible problem with that is a stress concentration in the shaft that
might cause it to break. Of course the keyway itself is a stress
concentration.

Paul Lamar


I agree, Paul

    Besides, once you know the key can be pushed out, then it is no problem
to double check to make certain it is in the key way.  The bent paper clip
check that Leon suggested sounds simple.  If the key is in the keyway, the
bent paper clip leg will not go in all the way.  If the bent leg of the
paper clip does go in all the way then your key is not in the keyway.

Ed Anderson

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org