Subject: Instalation details & 6 pinion report.
From: Paul
Date: 3/17/2001, 8:11 PM


SNIPS<

I just know I'm going to be shot down in flames with this but here goes
anyway!!  Another flash of brilliance I had was to use those "chipmunk
cheek" cowls a la standard Lyc/Con engines.  Doing it this way,  it
would
be possible to have the radiator/oil cooler arrangement split into 2
smaller units. I'm rather taken with those Lopresti cowls!!

Split rads and oil coolers worked really well with several Nova/Purvis
Eureka TCT (Totally Claustrophobic Transvestite) VW kit cars to which I
fitted rotaries in the '80s

The air for the 2 by 1300 Mazda rads, angled at 45 degrees very similar
to
formula car set ups was taken from the top and side scoops.  2 small
(half
width cut down RX7) oil coolers were placed up the front of the car and
got
their air from the nose scoops on either side.  Doing it this way in an
aircraft,  you retain the Lyc/Con cowl config,  and then there is plenty
of
room under the motor for a decent size muffler.



Tracy Crook wrote:

What you described is almost precisely why and what I did on my plane Leon.
Used a single  (stock Mazda) oil cooler though.  It all fit in the stock
cowl except for a small bump (only 3/4" high) for the alternator.  Building
a custom cowl is more work than most people think and if you'd rather spend
time flying rather than fabricating, keeping the stock cowl is a great time
saver.

The 6 pinion version of the redrive (RD1-B) is accumulating more hours on
the plane.  The difference is very subtle but it feels slightly smoother
than the 4 pinion.  Totally a guess, but the triangulated gears in the 6
pinion may be a more stable configuration than the 'square'  4 pinion setup.

The "boat tail" configuration on the muffler is holding up well and noise
level is now just acceptable.  I think it would be very quiet if I had the
non-turbo exhaust splitters.  Just got some .020" tubing (thanks to Brian
Trubee) which I plan to put around the muffler to form an additional baffle.
I'll get around to taking pictures of this soon.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org