Subject: Low level sensor for remote injector oil reservoir.
From: Paul
Date: 3/18/2001, 1:40 PM



I went to my local Rotary wrecking yard today to get a Brake low level
sensor, but upon looking at it, it looks as thught i will ahve to but  a
whole brake master cylinder in order to get one. also the innards of the
reservoir looked quite coplicated, almost as though there was some kind
of float in the neck of the thing.
I gues what I wasnt to ask is, what parts do you think I need,?,


David Doshay wrote:

This was my idea, so I'll try to help out. I just went out to look at my
'91 Rx7. I can't comment on how Mazda did this any other year.

Yes indeed, there is a float inside the brake fluid reservoir.
It contains the magnet that trips the switch when the oil level drops
and the magnet gets close to the switch, which sits at the bottom.
The switch is really easy to see: it is the black part with 2 wires
coming out of it at the bottom in the center of the reservoir. The
wires go towards the centerline of the car. The switch can be removed
easily by pinching the two little feet on the side of the reservoir to
the outside (driver's) of the reservoir. I just did it on my car to make
sure this works. I used long nose pliers to reach in and squeeze the
feet together. The switch slid right out. Note that the switch gets
tripped when there is still a few ounces of fluid in the reservoir.

When you see how Mazda used these parts it will be apparent how
one could make a custom reservoir for injection oil. Another idea
would be to use the Mazda plastic reservoir as is. The reservoir might
be smaller than one might want, but I don't think that you would run
out of injection oil in one tank of fuel, but I guess it will depend upon
the size of your tanks. If you are going to be injecting two-stroke oil
this way, you are going to be carrying it with you and checking it
every refuel anyway.

The only trick would be plumbing from the two large holes at the
bottom of the brake reservoir over to the metering pump. Mazda uses
2 large O-rings that hold the plastic part to the metal and prevent
brake fluid from leaking. One thought would be to use a gutted
master cylinder, but while this would be really easy, it is probably
a tad heaver than it needs to be. If you went this way you could add
to the capacity by building a new top reservoir that would screw onto
the Mazda part where the standard cap screws on.

David

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org