I am doing this manifold first as it is not practical to use a bent tube
manifold with the stock turbo. Its too tight of a package. Bent tube
manifolds work fine on a NA six port however. This is very similar if
not identical to the stock turbo manifold except it is much lower
profile and tuned for 6000 RPM. It does not have the exhaust heating
or water passages the stock manifold is burdened with.
John Lynch will be doing the final design and 3D milling of the casting
patterns and core boxes. Leon will be doing the casting and machining in
Australia. The renderings are Pro Cad practice for the actual runners.
The drawings so far are of the core only.
The manifold is designed to lay down on top of the rotor housings unlike
the stock Mazda intake manifold. This maximizes the clearance under the cowl
for those aircraft like the Kis Cruiser that need it. Long tubes
are bonded or tig welded into the sockets on this manifold. They are
spaced to clear the oil filler neck on the other side of the engine. I
considered making it out of fiberglass but the close proximity of the
hot turbo ruled that out.
If you have any suggestions I need to hear them now.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org