Subject: Design & Weight of Bell Housing was RE: Cast bell housing
From: Paul
Date: 3/19/2001, 5:16 PM

Leon Promet wrote:

Hi Chris,

STARTER POSITION.

May I ask why the standard position is a problem?  I'm looking at several
different starter positions,  and discussed them with Paul while he was
here..  I personally don't like the idea of the starter being on the
exhaust side,  especially with a turbo installation for both lateral weight
balance reasons,  and the fact that it is right next to the turbo outlet.
 Lots of heat never did ANY electrical device any good.  I'd like some
input before this thing is committed to metal.

WEIGHT

Remember that this bell housing will incorporate the actual mounting "ears'
as well,  and yes it will have a substantial flange to take a Tracey PSRU,
 so it might NOT be lighter.  The primary consideration here is strength,
and I will not compromise structural integrity  for an extra half a  Kg of
weight.

If weight is a REAL issue,  most people can easily lose 5 Kg simply by
eating correctly and exercising  (I know I have in the last 2 months,  and
I have another 5 Kg at least to go.  Too much sitting around on my butt in
front of  Monitor drinking too much Coke! {:>)).  A 1.25 litre bottle of
coke weighs about 1.25 Kg!  Think about it!!

The housing is the thing from which the whole aeroplane hangs in flight, as
well as taking all sorts of gyroscopic and torque loads, not to mention the
G forces from aerobatics and hard landings,  so it has to be bulletproof.
 Hence Paul's insistence on integral engine mounting points!

But rest assured that it won't have any unnecessary "fat" on it.  I come
from the school of "form follows function" engineering. It will look right
and BE right!

Cheers,

Leon Promet
peon@pacific.net.au

You know my position on this Leon. Everything must be above a straight line across the
bottom of the engine at the oil pan mounting surface so large area oblique mounted 
radiators can be accommodated under the engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org