Subject: Mike Wills inspired Glastar Mount
From: Paul
Date: 3/19/2001, 2:42 PM



Perry Casson wrote:

Attached are a couple photo's of my Mike Wills inspired
mount for a Glastar.
I have not done the final welding yet but I think it should
be solid enough
(comments more thaN welcome).  I guess my next plane will
have to use
Paul/Leon's cast housing...

All Tubes 3/4 x 0.049 4130
Front Brackets 1/8 4130
Rear Brackets 0.5" 6061

Perry Casson

Perry, like I told Mike you need some up and down bracing on
the rear mounts.
The front mount configuration is fine if not a bit space
consuming vis a vis
the rad under the engine trick and the cross tube. A lot like
my C182 BTW.

More about this (and your pictures) when I get a bit more time.

Paul Lamar

Perry Casson wrote:

Hi Paul,

Thanks for the comments, I did look a couple ways to form a complete
triangle on the rear mounts.  It would be tight but possible to run a 3rd
tube from the rear to front cups but that would eliminate the possibility of
a side mounted alternator which I think I'll need.  When I looked at the
loads on the rear two mounts (~ 15 lbs at 1G) and considered that several
mounts (Lancair 235 or see Bingelis's FWF book page 78) that actually only
have one tube running to the upper points I was pretty sure 2 short large
tubes would be overkill.  Not too late to reconsider though...

Perry


There is a more subtle thing going on here and it has to due with the
concept of redundant constraints. The rear mount sees torsion
due to the four mounts. The amount of torsion it sees depends on 
the distance between
all of the mounts and their stiffness. You would be better off with just
one rear mount that was properly triangulated. My choice would be the 
right rear looking at it from the pilots view. Take the other one 
on the water pump off and save the weight.
 
Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry-Casson-mm4.jpg