Perry Casson wrote:
Hi Paul,
Thanks for the comments, I did look a couple ways to form a complete
triangle on the rear mounts. It would be tight but possible to run a 3rd
tube from the rear to front cups but that would eliminate the possibility of
a side mounted alternator which I think I'll need. When I looked at the
loads on the rear two mounts (~ 15 lbs at 1G) and considered that several
mounts (Lancair 235 or see Bingelis's FWF book page 78) that actually only
have one tube running to the upper points I was pretty sure 2 short large
tubes would be overkill. Not too late to reconsider though...
Perry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org